UV Spot Curing for Electronics & PCB Assembly
Electronics assembly is where UV spot curing earns its keep: components tacked before reflow, wires staked against vibration, conformal coating repaired in seconds, connectors sealed. Fast, localized, no oven, throughput set by how quickly you index from joint to joint.
Boards are dense and heat-sensitive, and lines run fast. A concentrated UV spot fixes a bond in one to three seconds without heating the board, and multi-point or automated curing keeps pace with production. The right choice depends on your adhesive band and whether the cure is manual, fixtured, or on an automated line.
Recommended Systems
Manual benches and mixed chemistries, broad spectrum cures any tacking/staking adhesive at high intensity.
Quote the SunSpot 2Fixtured and automated lines, matched LED channels, instant on/off, and PLC/RS-232 control for repeatable, logged cures.
Quote the SkyBeamCuring Tasks in This Industry
Questions
What UV system is best for PCB assembly?
For manual benches and varied adhesives, the broad-spectrum SunSpot 2 cures any tacking or staking chemistry at high intensity. For fixtured or automated lines running a matched adhesive, the SkyBeam’s LED channels with programmable timers and PLC/RS-232 control give repeatable, logged cures.
Can UV curing keep up with an electronics production line?
Yes, a spot cure sets in one to three seconds, multi-point splitters or the SkyBeam’s four channels cure several joints per cycle, and the SkyBeam integrates with a PLC so the line triggers and logs each cure.
